Hi! We have some canopies in our project, but one of these canopies is 5w over-lighted. It's our understanding that we can make it up by under-lighting other tradable surface.

Dear sir/madam, For the area of mechanical ventilation, the actual design has no heating but ventilation.

Hi, It is possible to demand a future COP to comply with for future tenants and consider this value for the simulation (Eap2)? Thanks in advance.

Hallo everyone, I am modeling a C&S project with 8 floors, and system 7 will be used in the Baseline Case.

Hello!

Hello, We have received a review from LEED saying that for the baseline model there are inconsistencies between the demand values reported in Table EAp2-5 and Table 1.4. When completing Table 1.4

We submitted (on Jan 23, 2014) the question below. Unfortunately, since then my email has crashed and I have lost the response. Is there any way this can be recovered?

Mandatory provision 6.4.3.2 Setpoint Overlap Restriction When heating and cooling to a zone is controlled by separate thermostatic controls shall heating setpoint exceed cooling setpoint. In our C&

In our project location, it is clear that no tenants will go for a heating system. The base building is also designed for cooling only.

In a LEED CS 2009 building energy simulation: we are modeling the building envelope to test performance (only the building envelope).