Post a question or comment
Credit Filters
Filter by location
Forum
Topic
Replies
Recent

Sefaira Software for Daylight calculation - sDA and ASE

CS-v4 EQc4:Daylight
posted by  Nuttanee Vongveeranonchai  on 

Dear All, 

I found that Sefaira has calculated sDA and ASE which are required for LEED v4 Daylight compliance. Can I use this result for the submission? 

1
Fri May 18, 2018, 11:57 am

Rainwater Events Calculator v4

NC-v4 SSc4:Rainwater management
posted by  Carmen Mielecke  on 

Dear all, my 2 question refer to the rainfall events calculator. 1) the percentil is calculated on the historical data sheet. The amount is expressed in mm.

3
CEO
LCEE Life Cycle Engineering Experts
LEEDuser Basic Member
4 thumbs up
Fri May 18, 2018, 11:36 am

Enhanced Commissioning

CI-v4 EAc1:Enhanced commissioning
posted by  Lance Barron  on 

Is building envelope commissioning required for CI if the exterior walls and roof are not being touched? Thanks.

0
2
CEO
Green Commons, LLC
LEEDuser Expert
586 thumbs up
Thu May 17, 2018, 5:35 pm

Dual Flush Flow Rate

NC-v4 WEp2:Indoor water use reduction
posted by  Leanne Conrad  on 

We have a product data sheet for a dual flush toilet that states 6L/3L with an effective flush volume of 4L.

3
Sustainability Director, Certifications & Compliance
Jacobs
LEEDuser Expert
469 thumbs up
Thu May 17, 2018, 1:54 am

Hoarding dimensions

NC-v4 SSp1:Construction activity pollution prevention
posted by  Ahmed Labeeb  on 

Dear All,

Is there any LEED requirement regarding the hoarding dimensions ( distance from ground to the bottom of the panel)?

2
UAE
P&T Architects
LEEDuser Basic Member
1 thumbs up
Thu May 17, 2018, 1:52 am

SSp2 Environmental Site Assessment

Schools-NC-v4 SSp2:Environmental site assessment
posted by  Karly Michalowski  on 

I have a LEEDv4 for Schools project but is focusing on the interior restoration of the building and not site. Is Phase I ESA required for just interior restoration of the building?

2
Founder & Community Director
Metricorps
LEEDuser Expert
7780 thumbs up
Wed May 16, 2018, 2:47 pm

Not eligible if no non-potable water?

CI-v4 IPc1:Integrative process
posted by  emily reese moody  on 

It appears that a project may not be eligible for the 1 point associated with the Water Related System if their building(s) do not offer non-potable water sources. Is this correct?

4
LEED Fellow
7group / Energy Opportunities
LEEDuser Expert
4454 thumbs up
Wed May 16, 2018, 2:01 am

Using CBECS 2012 Data for Estimating Energy Consumption

CI-v4 EAp2:Minimum energy performance
posted by  Oliver Bate  on 

I have multiple office projects where there is no consumption data available as the tenants are new to the building- we are going with Option 2 Minimum Energy Performance. 

13
LEED Fellow
7group / Energy Opportunities
LEEDuser Expert
4454 thumbs up
Wed May 16, 2018, 12:18 am