We are working on a retail/catering facility that we cannot currently certify as NC because the addition we are doing is not large enough to qualify.

Hi I receive several MSDS for the coatings that will be used in our project and inside them, the VOC content is measured in Europe (EU) which are usually expressed in percentage % (w/w).

Our project has access to 2 bus stops, 1 located just outside of the building's perimeter with 2 bus lines and the other one is the main one, whit main it means that's the one the 90% of the people

I'm working on finalizing documentation for a LEED project. We have completed the calculations and are only looking about 15% savings.

One LEED site boundary has two individual LEED projects that are under construction under one contract by the same GC.

As 1.6 is a standard low flow toilet, in order to further reduce water use is it better to specify a 1.28 gpf or a dual flush toilet? Thank you.

I'm not sure why this point is necessary, to be completely honest.

Hi all, We have a small LEED:CI project in a CS certified shopping mall. We don't have any direct outdoor air intakes, we take the air from the main atrium and give it to our space.

Hi all, We have a CI project in a CS v2009 certified project which achieved the development density points.

If we have a LEED Project that was pursuing a Pilot Credit but without knowing that it was a Pilot Credit, and are at the Submission Phase can we still apply for this credit.