What is the methodology for LEED projects to claim credits (if possible?) for natural ventilation in dwelling units?

In the courtyard of the building that I’m modelling two charging columns for electric vehicles are going to be installed. Shall I consider them as process energy?

According to system 3 of Table G3.1.1A I have to model a fossil fuel furnace for a baseline model. What efficiency shall I consider? "Warm air unit heater, gas-fired" in Table 6.8.1E, i.e. 80%?

The proposed project is located in an island and the intent is to locate bungalow cabins over water in piers (see: http://www.islands.com/gallery/top-19-overwater-bungalow-resorts) along with some

...is calculated automatically by the energy simulation tool we use according to appendix G13.1.2.9.

LEED review for one of our projects states "Ensure that no credit is taken in the Proposed Design Case for lighting reductions on non-tradable surfaces.

Most all of our buildings have a combo of mechanical ventilation (e.g. in hallways) and natural ventilation (e.g. in residence hall rooms).

Hello All In this LEED_CS project, the existing masonry wall was changed to the following configuration (from outside to inside): - glass-fiber-reinforced concrete panels [TAKTL] on galvanized st

We are trying to acheive SSc5.1, we are missing few m2. Is it possible to use grasscrete in a drive way with adaptive grass?

I'm working on an NC assisted living facility with a bus transit terminal within a 1/2 mile of the property (not the 1/4 mile requirement).