Has anyone successfully pursued Option 2 Case 2 (blower door testing) for type 1B multi-family project?

Does anybody have any experience with this new tool or know whether any further guidance on how it should be used is available? I have two questions in particular: 1) How is the baseline electrica

We are planning on certifying a school addition. The existing building is not certified and there will be a clear boundary between the addition and existing building.

Even though the credit language does not state it explicitly, I read "reduce design energy cost compared with the energy cost budget for regulated energy components" to mean "reduce the design ener

I was wondering if there is a minimum set of comfort parameters which HAVE TO be measured by the BAS.

Hello everybody. I have a question: Is installation of fan motors with variable frequency drive in main AHUs an acceptable option of outdoor air measurement? I went through credit interpretations,

If there is a water feature in the landscape, that is counted within this credit, correct?

This LEEDuser forum is intended to cover Project Information Form 1, which is about documenting compliance with the MPRs.

Finding very difficult to get manufacturer recommended calibration intervals. Is there a code or governing body that can be used as a guide such as NSF or AWWA

Hello, Fact or Fiction: For EAp2 ASHRAE 90.1 §6.4.1.5.1 all mechanical Equipment must have a Label installed by the manufacturer stating that the equipment complies with the requirements of Standa