We are submitting a 90,000 SF Humanities Building on a commuter campus. The agency owner has eliminated practically all interior parking over the last 5 years.

I have about 35 ceiling- mounted heat pumps throughout the building, and it would be cost-prohibitive to install a separate meter on each one.

We have a Student Housing Development Project in Cincinnati. We are seeking the exemplary Performance Credit for Alternative Transportation Public Transportation Access.

Hey All, This question is basically for the energy modelers out there who use HAP or any other software. I have a conditioned lobby where the fan coil just uses the return air, according to our ca

Do these certifications meet the requirements for furniture?

How are 3 year aged SR values determined for concrete if not available by the manufacturer?

All, We submitted a dormitory project for a university in which there was a very substantial amount of existing parking between our new building and another part of our project (a new, relatively

Plf4 was not approved because GBCI is asking int & ext photos & renderings of the building. This was Design Preliminary submission and construction has just started.

I am modeling a new building(Laboratory/office) on a university campus following LEED v4 Option 1, Whole Building Energy Simulation. New Building is 3 story and 69,500 sq.ft .

Our current project is located on a plot of land that 3/4 of it was developed into commercial retail.