See all forum discussions about NC-2009 IEQc8.1
 Subscribe to new posts about NC-2009 IEQc8.1 Post a new question aboutNC-2009 IEQc8.1
See LEEDuser’s guidance on NC-2009 IEQc8.1»
FAQs about IEQc8.1 :

Do I need to submit the Supplemental Views and Daylight Calculator?

Can I average the compliant square footage between 9 a.m. and 3 p.m. for a space and use the average as the compliant square footage?

Can I use Option 2: Prescriptive method if I have....?

When should daylight measurements be taken?

Do I need to have glare control devices?

Where can I find the Supplemental Views and Daylight Calculator?

View answers »

Forum discussion

NC-2009 IEQc8.1:Daylight and Views—Daylight

Option 3 - Measurement. Height?

Hello - Could you please confirm the measurement height for the daylight readings? Is this the workplane, floor, or other height? Thank you very much - Candice

0
Post a reply

You rely on LEEDuser. Can we rely on you?

LEEDuser is supported by our premium members, not by advertisers.

Go premium for $15.95  »

Profile picture for user treed74
TODD REED
Energy Program Specialist
PA DMVA
LEEDuser Expert
626 thumbs up

Tue, 10/09/2012 - 12:44

30 inches or work plan height. So if you have a lab, and the tables are higher than your standard counter, then use that height. Make sure you note any differences you use in the height measured and the reasons why.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.